CCTVPLANNER.IO · NVR · KENIK
Kenik KG-NVR6016128R
128-channel enterprise NVR with 16 hot-swap bays, RAID 0/1/5/10 and 8K HDMI output
SPECIFICATIONS · KG-NVR6016128R
Full specifications
Specifications sourced from official manufacturer datasheet (link in hero).
About the Kenik KG-NVR6016128R
The Kenik KG-NVR6016128R is a high-density recorder built for city-scale, campus, and critical-infrastructure deployments where a single unit replaces a stack of smaller NVRs and consolidates licensing into one chassis. Bay count and per-bay capacity scale to multi-petabyte recording arrays, supporting six-month-plus retention windows or sites with very high per-camera bitrates (4K/8K). The chassis is built around storage density rather than channel count. The desktop chassis sits on a shelf, IT bench or wall-mount tray and runs cool enough that ventilation is not a serious design constraint. No PoE ports are built into the recorder, so cameras connect through a separate PoE switch. That is the preferred architecture on professional installs because a dedicated managed switch gives finer VLAN control, larger PoE budgets, and easier replacement than an integrated switch tied to the NVR chassis.
Best use cases for this recorder
Campus, factory, logistics & critical infrastructure
At 128 channels per chassis, the unit consolidates what would otherwise be 2-4 mid-range NVRs into a single rack appliance. Useful where licensing per-chassis matters and where consolidating storage onto one RAID set simplifies forensic retrieval.
4K/8MP camera deployments
Native support for 12 MP per-channel recording matches it to current-generation 4K cameras — useful when the install plan calls for fewer-but-higher-resolution cameras (typical of perimeter, parking, and identification-focused layouts).
Long-retention archive & evidentiary recording
16 HDD bays at up to 22 TB each give the unit petabyte-class storage capacity, supporting 6-12 month retention windows mandated by some banking, retail-loss-prevention, and public-transport contracts.
Strengths
- •128-channel headroom absorbs phased expansion without forcing a second chassis
- •16 HDD bays support RAID protection for evidentiary recording
- •RAID 0/1/5/10 support protects archive against single-disk failure
- •Smart H.265+ codec halves storage cost over H.265 at equivalent perceived quality
- •ONVIF compliance lets the unit record from third-party cameras, not just the same-brand catalog
Considerations
- •No built-in PoE — budget for a separate managed PoE switch with appropriate per-port wattage for the planned cameras
Storage planning
Running all 128 channels at the industry-typical 4 Mbps/channel H.265 CBR (15 fps, 4 MP scene complexity), the KG-NVR6016128R produces roughly 5530 GB of footage per day — about 38707 GB/week, 165888 GB/month, and 497664 GB across a 90-day retention window. Fully populated with 16× 22 TB drives the unit holds 352 TB raw — enough for roughly 2.2× the one-month archive at full bitrate before RAID overhead. These figures are deterministic — derived from your bitrate assumption, the channel count, and the calendar — not estimated from a marketing data sheet.
Estimates assume 4 Mbps per channel H.265 CBR continuous recording. Motion-only recording typically reduces storage by 40-70%.
Bandwidth headroom
Input (ingest)
Avg 8.0 Mbps per channel — enough for 4K H.265 at 4 Mbps/channel.
Output (playback)
Sets the ceiling for simultaneous remote playback streams to mobile and web clients.
Installation tips for the KG-NVR6016128R
Locate on a shelf in a ventilated, lockable cupboard — desktop units pull dust through the chassis quickly when sat on a carpeted floor, and the HDDs need ambient temperatures under 30 °C for rated life.
Plan storage at roughly 5530 GB/day (≈165888 GB/month) for continuous H.265 recording at 4 Mbps/channel — match HDD capacity to the longest retention window the privacy policy or insurance contract demands.
Use RAID 5 (one-disk parity) for general-purpose archive or RAID 6 (two-disk parity) for evidentiary recording — RAID 10 is fastest but burns half the bays on mirroring, only worth it when write performance is the bottleneck.
Pair with a managed PoE switch sized for the camera plan — choose 802.3at (≤30 W/port) for typical IR-equipped bullets, 802.3bt (≤60-90 W/port) when PTZ or heated housings are in scope.
Power & rack
Power draw sits at roughly 110 W idle and around 110 W under full load (16-bay HDD activity). That dissipates approximately 375 BTU/hour of heat into the rack — size the comms-cabinet ventilation accordingly. On desktop placement, raise the unit on rubber feet or a vented tray rather than directly on carpet — the chassis pulls cooling air through bottom intakes and dust ingress is the primary cause of premature HDD failure.
Installer time & cost (rough estimate)
A typical EU integrator quotes 20-22 h of labour to commission the Kenik KG-NVR6016128R (approximately €900-€990 excluding hardware), broken down as physical install, HDD population and RAID set-up, 128-channel discovery and IP/credential configuration, schedule + retention setup, motion / event rules per camera, mobile-app pairing, and a brief operator handover. Allow extra time for sites with non-standard network topology (multi-VLAN, multi-site bridges) or for migrations from a legacy DVR where camera streams must be re-addressed.
Indicative EU 2024-2025 pricing — actual quotes vary by region, network topology and migration scope. Excludes hardware, HDDs, transport, permits, and VAT.
Frequently asked questions
How many cameras can the Kenik KG-NVR6016128R record?
Up to 128 IP camera channels per chassis. Total ingest bandwidth is 1024 Mbps, which sets the practical ceiling — running every channel at 4K (typically 8 Mbps each) requires 1024 Mbps, so verify whether your camera plan fits inside the bandwidth budget.
Does the Kenik KG-NVR6016128R support third-party (ONVIF) cameras?
Yes — ONVIF Profile S/T support means the unit records from third-party cameras as well as the same-brand catalog. Most cameras supporting ONVIF 16.12 or newer plug-and-play; older firmware may require manual stream URL configuration in the NVR web UI.
How much storage does the Kenik KG-NVR6016128R need for 30-day recording?
At the industry-typical 4 Mbps per channel H.265 CBR (15 fps, 4 MP scene), all 128 channels recording continuously for 30 days produces approximately 165888 GB (162.0 TB) of footage. Motion-only or event-triggered recording typically cuts that by 40-70 % depending on scene activity. Plan HDD capacity for the longest retention window your privacy policy or insurance contract demands.
What HDDs are recommended for the Kenik KG-NVR6016128R?
Use surveillance-rated HDDs — WD Purple, Seagate SkyHawk, Toshiba S300, or equivalent. Desktop / consumer drives (WD Blue, Seagate Barracuda) are not validated for 24/7 write workloads and typically fail within 12-18 months in CCTV use. Max 22 TB per bay across 16 bays = up to 352 TB raw capacity; populate matched pairs/sets if planning RAID.
Does the Kenik KG-NVR6016128R need its own PoE switch?
Yes — the recorder has no built-in PoE, so cameras connect through a separate managed PoE switch. Size the switch's PoE budget for the planned cameras: 802.3at (≤30 W/port) handles typical IR-equipped bullets and domes; 802.3bt (≤60-90 W/port) is needed for PTZ and heated housings.
What power and cooling does the Kenik KG-NVR6016128R need?
Plan for 110 W idle and ~110 W under full load, dissipating roughly 375 BTU/hour into the rack or cupboard. Size the UPS for at least 15-minute hold-up so the unit can flush write buffers and shut down cleanly on mains failure — abrupt power loss is the leading cause of NVR file-system corruption in commercial installs.
Is the Kenik KG-NVR6016128R suitable for evidentiary recording?
Yes — RAID 0/1/5/10 support protects archive against single-disk (or two-disk on RAID 6) failure, and channel headroom supports the typical 30-90 day retention required by Polish and EU evidentiary policies. Export footage via the web UI or front-USB; native hash signing ties the export to the source archive.
Related Kenik NVRs
Compare with similar-channel NVRs from other brands
Compatible cameras for the Kenik KG-NVR6016128R
This recorder handles up to 128 channels at up to 12 MP per channel. These verified catalogue cameras stay within that per-channel ceiling and connect over ONVIF — add any of them to a plan and CCTVplanner sizes the storage and PoE budget automatically.
Kenik
Kenik KG-12315FAS-I
12.3MP (3504×3504) · Panoramic Camera · 15m
Kenik
Kenik KG-12015FAS-I
9.0MP (3008×3000) · Panoramic Camera · 15m
Kenik
Kenik KG-8G70TZAS-ILCD
8.3MP (3840×2160) · Bullet Camera · 10m
Kenik
Kenik KG-8G60TAS-ILCD-B (2.8mm)
8.3MP (3840×2160) · Bullet Camera · 11m
Kenik
Kenik KG-8G60TAS-ILCD (2.8mm)
8.3MP (3840×2160) · Bullet Camera · 11m
Kenik
Kenik KG-8G40VZAS-ILCD
8.3MP (3840×2160) · Dome Camera · 12m
Helpful Tools & Resources
Free CCTV Design Tool
Plan a full camera layout online — no download, free to start
Camera Placement Tool
Position cameras on a real floor plan and see live DORI coverage
Storage Calculator
Match HDD capacity to your retention policy
Bandwidth Calculator
Verify your network can carry the ingest load
Camera Quantity Calculator
Match channel count to your site
UPS Sizing Calculator
Hold-up time for clean NVR shutdown on mains failure
System Budget Estimator
Hardware + install + commissioning cost
CCTV Storage Planning Guide
Bitrate, retention, RAID — the full math
Plan your CCTV layout with Kenik KG-NVR6016128R
Use our free CCTV planner to lay out cameras feeding this recorder, match HDD capacity to retention windows, and generate a professional PDF report — no signup required.
Free until you outgrow it · No card · No install