Amcrest Amcrest IP5M-T1277EW-AI 5MP AI Turret

SPECIFICATIONS · AMCREST IP5M-T1277EW-AI 5MP AI TURRET

About the Amcrest Amcrest IP5M-T1277EW-AI 5MP AI Turret

The Amcrest Amcrest IP5M-T1277EW-AI 5MP AI Turret is a weather-sealed bullet housing optimized for perimeter, parking, and exterior building installations. At 5-to-6MP the sensor sits between 1080p economy and 4K forensic detail: enough pixels-per-metre for evidence-grade faces at typical entrance and driveway distances, while keeping recording bitrate materially lighter than an 8MP camera. A 50–80 m IR range turns this into a true night-perimeter camera — open yards, fenced lots, and rural properties become practical use cases without supplemental lighting. An ultra-wide angle (>120°) captures nearly an entire scene from one position, but pixels per meter drops sharply at the edges, so identification at the periphery is limited. The Super Low Light sensor is the feature most installers care about for residential and parking-lot use — it preserves identification detail when older cameras lose all color and most contour.

Best use cases for this camera

Coverage at Different Distances

Field of View Visualization

Night Vision Performance

Installation tips for the Amcrest IP5M-T1277EW-AI 5MP AI Turret

Coverage geometry & DORI distances

At a 5-metre standoff the Amcrest Amcrest IP5M-T1277EW-AI 5MP AI Turret covers about 21.0 m of scene width; at 10 m that grows to 41.9 m, and at 20 m to 83.9 m. Translating those numbers through EN 62676-4 pixel-density thresholds, the camera can detect a person up to 28 m, observe up to 11 m, recognise up to 6 m, and produce identification-grade detail (the ≥250 px/m bar used by Polish and EU courts as evidentiary) up to 3 m. Effective range above the identify threshold relies on supplementary lighting or a longer-focal-length optic — the geometry above assumes the 2.8mm lens declared by the manufacturer.

Power & cabling

The Amcrest Amcrest IP5M-T1277EW-AI 5MP AI Turret draws an estimated 12.0 W under typical load (with the IR illuminator engaged where applicable), placing it in the 802.3af (Class 3, ≤15.4 W) budget. A single switch port supplies enough power without an injector. Cabling: stick to Cat6 STP for runs up to 100 m end-to-end — beyond that, add an inline PoE extender or move to fibre with a media converter at the camera end. On outdoor runs, route through ø25 PVC or PE conduit to keep the cable shielded from UV and rodents.

Privacy & legal (GDPR / RODO)

Any camera operating in a publicly accessible area falls under GDPR (RODO in Poland) — Art. 13 obliges the data controller to post an information sign at every entry point with controller name, DPO contact, lawful basis (typically Art. 6(1)(f) legitimate interest for property protection), purpose, and retention period. Even a narrowly-aimed turret camera can incidentally record passers-by, so the Art. 13 sign at the entry point applies regardless of how tightly the lens is framed.

Installer time & cost (rough estimate)

A typical EU installer quotes 3–4 h of labour per turret camera of this class (approximately €135–€185 excluding hardware), broken down as bracket mounting, cable termination at both ends, on-site commissioning, and a brief operator handover. Allow extra time for high mounts (>4 m), exterior installations requiring scaffolding, or sites where cable routing demands wall penetrations or conduit work.

Indicative EU 2024-2025 pricing — actual quotes vary by region, mounting height, and site conditions. Excludes hardware, transport, permits, and VAT.

Frequently asked questions

Related Amcrest Turret Cameras

Other Amcrest cameras

Helpful Tools & Resources