CCTVPLANNER.IO · CAMERA · ACTI

    ACTi ACTi I99

    Dome Camera with 10.0MP (3648×2736) resolution, 95° field of view, and 35m IR night vision range.

    NO.01
    10MP
    Resolution
    NO.02
    95°
    Horizontal FOV
    NO.03
    15m
    Effective Range
    NO.04
    35m
    IR Range

    SPECIFICATIONS · ACTI I99

    Specifications

    Resolution10.0MP (3648×2736)
    Focal Length3.1-13mm
    Horizontal FOV95°
    Effective Range15m
    IR Range35m
    TypeDome Camera
    Low LightStandard

    About the ACTi ACTi I99

    The ACTi ACTi I99 is a low-profile dome enclosure that blends into ceilings, vandal-resistant by design and harder to tamper with than bullet cameras. Ultra-high resolution above 8MP is reserved for situations where one camera must replace several — large open atriums, parking decks, and stadium seating areas where digital zoom on a single feed substitutes for multiple cameras. Medium IR range (20–40 m) is appropriate for typical residential driveways, small commercial perimeters, and back-of-house loading bays where reach beyond ~30 m is rarely needed at night. A wide 80–120° angle covers a large room or open area from a single mounting position, making it ideal for retail floors, conference rooms, and small parking lots.

    Best use cases for this camera

    Entrance, lobby & vestibule

    The 95° field of view captures the entire entrance and surrounding waiting area from a single ceiling mount. Useful for capturing visitors as they enter and leave.

    Retail & office interior

    Dome form factor and 10.0MP (3648×2736) resolution make this a clean retail/office choice — the housing blends into ceilings and the sensor delivers enough detail for POS-area monitoring and incident review.

    Strengths

    • 10MP sensor preserves detail under digital zoom on recorded footage
    • 95° wide field of view reduces the number of cameras needed per area
    • Vandal-resistant dome housing harder to tamper with than bullet form factor

    Considerations

    • Higher resolution increases storage and bandwidth requirements proportionally — verify NVR capacity

    Coverage at Different Distances

    DistanceCoverage WidthCoverage AreaUse Case
    5m10.9m55Entrance, corridor
    10m21.8m218Room, retail aisle
    15m32.7m491Warehouse, parking row
    20m43.7m873Parking row, courtyard
    30m65.5m1964Parking lot, yard
    50m109.1m5457Perimeter, large area

    Field of View Visualization

    Camera15m95° FOVEffective rangeIR range (35m)

    Night Vision Performance

    Daytime

    Full 10.0MP (3648×2736) resolution at 95° field of view. Effective identification range up to 40m in good lighting conditions.

    Nighttime (IR)

    Built-in IR LEDs illuminate up to 35m in complete darkness. Switches to B/W mode for clear night footage.

    Installation tips for the ACTi I99

    1

    Ceiling-mount at 2.5–3.5 m for indoor use; for vandal-prone outdoor locations use a wall mount with the lens facing outward and downward.

    2

    Position so the most important subject (entrance, cash register, gate) is in the center third of the frame — peripheral pixel density drops with wide angles.

    3

    Plan storage at roughly 40 GB per camera per day for continuous H.265 recording at 15fps — verify NVR has sufficient HDD bay capacity.

    Coverage geometry & DORI distances

    At a 5-metre standoff the ACTi ACTi I99 covers about 10.9 m of scene width; at 10 m that grows to 21.8 m, and at 20 m to 43.7 m. Translating those numbers through EN 62676-4 pixel-density thresholds, the camera can detect a person up to 77 m, observe up to 31 m, recognise up to 15 m, and produce identification-grade detail (the ≥250 px/m bar used by Polish and EU courts as evidentiary) up to 8 m. Effective range above the identify threshold relies on supplementary lighting or a longer-focal-length optic — the geometry above assumes the 3.1-13mm lens declared by the manufacturer.

    Detect
    77 m
    Observe
    31 m
    Recognise
    15 m
    Identify
    8 m

    Power & cabling

    The ACTi ACTi I99 draws an estimated 7.5 W under typical load (with the IR illuminator engaged where applicable), placing it in the 802.3af (Class 3, ≤15.4 W) budget. A single switch port supplies enough power without an injector. Cabling: stick to Cat6 STP for runs up to 100 m end-to-end — beyond that, add an inline PoE extender or move to fibre with a media converter at the camera end. On outdoor runs, route through ø25 PVC or PE conduit to keep the cable shielded from UV and rodents.

    Privacy & legal (GDPR / RODO)

    Any camera operating in a publicly accessible area falls under GDPR (RODO in Poland) — Art. 13 obliges the data controller to post an information sign at every entry point with controller name, DPO contact, lawful basis (typically Art. 6(1)(f) legitimate interest for property protection), purpose, and retention period. Even a narrowly-aimed dome camera can incidentally record passers-by, so the Art. 13 sign at the entry point applies regardless of how tightly the lens is framed.

    Installer time & cost (rough estimate)

    A typical EU installer quotes 3–4 h of labour per dome camera of this class (approximately €135–€185 excluding hardware), broken down as bracket mounting, cable termination at both ends, on-site commissioning, and a brief operator handover. Allow extra time for high mounts (>4 m), exterior installations requiring scaffolding, or sites where cable routing demands wall penetrations or conduit work.

    Indicative EU 2024-2025 pricing — actual quotes vary by region, mounting height, and site conditions. Excludes hardware, transport, permits, and VAT.

    Frequently asked questions

    Is the ACTi ACTi I99 suitable for outdoor installation?

    Yes for the IP66/IP67-rated variant of this model. Bullet and dome bodies in the ACTi range survive direct rain, snow and UV; check the IP / IK rating against your environment (IP66 for rain/dust, IK10 for vandal-prone locations).

    What PoE class powers the ACTi ACTi I99?

    The camera draws roughly 7.5 W in steady-state operation, requiring a 802.3af (Class 3, ≤15.4 W) switch port. A single Cat6 STP cable carries both data and power up to 100 m — beyond that, add an inline extender or convert to fibre near the camera.

    How much storage does the ACTi ACTi I99 consume per day?

    At 10.0MP (3648×2736) resolution, 15 fps H.265 continuous recording, the ACTi I99 produces approximately 40 GB per day — about 1200 GB per month. Motion-only or event-triggered recording typically cuts that by 40–70 % depending on scene activity. Plan NVR HDD capacity for the longest retention period required by your privacy policy or insurance contract.

    Up to what distance can the ACTi ACTi I99 identify a person?

    Per EN 62676-4:2025 pixel-density thresholds, this camera identifies (≥ 250 px/m on the target) up to about 8 m, recognises a person up to 15 m, observes general activity up to 31 m, and detects motion up to 77 m. Identification distance assumes daylight or full IR illumination on the target — at the limits of the IR cone the effective identify distance shrinks roughly 30 %.

    What network bandwidth does ACTi ACTi I99 use?

    Typical ingest is 15 Mbps for the main stream (H.265, medium scene complexity, 15 fps) plus ~0.5 Mbps for a low-resolution sub-stream used by mobile clients. For a 16-camera installation of this class, plan a 50–100 Mbps NVR uplink and a dedicated VLAN for camera traffic.

    Related ACTi Dome Cameras

    Other ACTi cameras

    Helpful Tools & Resources

    Plan your layout with ACTi ACTi I99

    Use our free CCTV planner to place this camera on your floor plan, see real-time field of view coverage, and generate a professional PDF report.

    Free until you outgrow it · No card · No install