CCTVPLANNER.IO · NVR · UNIVIEW

    Uniview NVR301-16S3

    16-ch compact NVR, 1 HDD bay, no PoE, 4K

    View official datasheet
    NO.01
    16
    Channels
    NO.02
    1
    HDD Bays
    NO.03
    10 TB
    Max Raw Storage
    NO.04
    0
    PoE Ports

    SPECIFICATIONS · NVR301-16S3

    Full specifications

    Channels16
    Max Resolution4K
    Input Bandwidth64 Mbps
    Output Bandwidth48 Mbps
    HDD Bays1
    Max HDD per Bay10 TB
    PoE Ports0
    PoE BudgetN/A
    CodecsH.265, H.264
    RAID SupportNone
    ONVIFYes
    Form Factordesktop
    Network Ports1× 10/100 RJ-45
    Alarm I/ON/A

    Specifications sourced from official manufacturer datasheet (link in hero).

    About the Uniview NVR301-16S3

    The Uniview NVR301-16S3 is a mid-channel recorder positioned for the most common SMB site — typical retail chains, mid-sized offices, warehouses and clinics that sit between roughly eight and sixteen cameras. Built-in HDD capacity is intentionally lean; the unit is meant to be paired with a NAS, cloud archive, or sister recorder when retention beyond ~14 days at full bitrate is mandated. The desktop chassis sits on a shelf, IT bench or wall-mount tray and runs cool enough that ventilation is not a serious design constraint. No PoE ports are built into the recorder, so cameras connect through a separate PoE switch. That is the preferred architecture on professional installs because a dedicated managed switch gives finer VLAN control, larger PoE budgets, and easier replacement than an integrated switch tied to the NVR chassis.

    Best use cases for this recorder

    4K/8MP camera deployments

    Native support for 4K per-channel recording matches it to current-generation 4K cameras — useful when the install plan calls for fewer-but-higher-resolution cameras (typical of perimeter, parking, and identification-focused layouts).

    Strengths

    • H.265 codec roughly halves storage cost over legacy H.264 installs
    • ONVIF compliance lets the unit record from third-party cameras, not just the same-brand catalog
    • Compact chassis fits in a half-height comms cabinet or office bench

    Considerations

    • No built-in PoE — budget for a separate managed PoE switch with appropriate per-port wattage for the planned cameras
    • Single HDD bay means no RAID protection — schedule regular backups or pair with a secondary NVR/NAS for redundancy
    • Average per-channel ingest budget is below typical 4K bitrates — restrict high-MP channels or accept lower bitrate per camera
    • No RAID support — single-disk failure means losing all footage on that disk; plan retention policy accordingly

    Storage planning

    Running all 16 channels at the industry-typical 4 Mbps/channel H.265 CBR (15 fps, 4 MP scene complexity), the NVR301-16S3 produces roughly 675 GB of footage per day — about 4725 GB/week, 20250 GB/month, and 60750 GB across a 90-day retention window. Fully populated with 1× 10 TB drives the unit holds 10 TB raw — enough for roughly 0.5× the one-month archive at full bitrate before RAID overhead. These figures are deterministic — derived from your bitrate assumption, the channel count, and the calendar — not estimated from a marketing data sheet.

    1 day
    675 GB
    7 days
    4.6 TB
    30 days
    19.8 TB
    90 days
    59.3 TB

    Estimates assume 4 Mbps per channel H.265 CBR continuous recording. Motion-only recording typically reduces storage by 40-70%.

    Bandwidth headroom

    Input (ingest)

    64 Mbps

    Avg 4.0 Mbps per channel — enough for all channels at full 4MP H.265 at 4 Mbps/channel.

    Output (playback)

    48 Mbps

    Sets the ceiling for simultaneous remote playback streams to mobile and web clients.

    Installation tips for the NVR301-16S3

    1

    Locate on a shelf in a ventilated, lockable cupboard — desktop units pull dust through the chassis quickly when sat on a carpeted floor, and the HDDs need ambient temperatures under 30 °C for rated life.

    2

    Plan storage at roughly 675 GB/day (≈20250 GB/month) for continuous H.265 recording at 4 Mbps/channel — match HDD capacity to the longest retention window the privacy policy or insurance contract demands.

    3

    Schedule weekly off-site backups (NAS, cloud, or sister NVR) since the single-bay design has no internal redundancy — a failed disk loses the entire archive.

    4

    Pair with a managed PoE switch sized for the camera plan — choose 802.3at (≤30 W/port) for typical IR-equipped bullets, 802.3bt (≤60-90 W/port) when PTZ or heated housings are in scope.

    Power & rack

    Power draw sits at roughly 35 W idle and around 35 W under full load (1-bay HDD activity). That dissipates approximately 119 BTU/hour of heat into the rack — size the comms-cabinet ventilation accordingly. On desktop placement, raise the unit on rubber feet or a vented tray rather than directly on carpet — the chassis pulls cooling air through bottom intakes and dust ingress is the primary cause of premature HDD failure.

    Idle
    35 W
    Full load
    35 W
    Heat
    119 BTU/h

    Installer time & cost (rough estimate)

    A typical EU integrator quotes 5-7 h of labour to commission the Uniview NVR301-16S3 (approximately €225-€315 excluding hardware), broken down as physical install, HDD population, 16-channel discovery and IP/credential configuration, schedule + retention setup, motion / event rules per camera, mobile-app pairing, and a brief operator handover. Allow extra time for sites with non-standard network topology (multi-VLAN, multi-site bridges) or for migrations from a legacy DVR where camera streams must be re-addressed.

    Indicative EU 2024-2025 pricing — actual quotes vary by region, network topology and migration scope. Excludes hardware, HDDs, transport, permits, and VAT.

    Frequently asked questions

    How many cameras can the Uniview NVR301-16S3 record?

    Up to 16 IP camera channels per chassis. Total ingest bandwidth is 64 Mbps, which sets the practical ceiling — running every channel at 4K (typically 8 Mbps each) requires 128 Mbps, so verify whether your camera plan fits inside the bandwidth budget.

    Does the Uniview NVR301-16S3 support third-party (ONVIF) cameras?

    Yes — ONVIF Profile S/T support means the unit records from third-party cameras as well as the same-brand catalog. Most cameras supporting ONVIF 16.12 or newer plug-and-play; older firmware may require manual stream URL configuration in the NVR web UI.

    How much storage does the Uniview NVR301-16S3 need for 30-day recording?

    At the industry-typical 4 Mbps per channel H.265 CBR (15 fps, 4 MP scene), all 16 channels recording continuously for 30 days produces approximately 20250 GB (19.8 TB) of footage. Motion-only or event-triggered recording typically cuts that by 40-70 % depending on scene activity. Plan HDD capacity for the longest retention window your privacy policy or insurance contract demands.

    What HDDs are recommended for the Uniview NVR301-16S3?

    Use surveillance-rated HDDs — WD Purple, Seagate SkyHawk, Toshiba S300, or equivalent. Desktop / consumer drives (WD Blue, Seagate Barracuda) are not validated for 24/7 write workloads and typically fail within 12-18 months in CCTV use. Max 10 TB per bay across 1 bays = up to 10 TB raw capacity; populate matched pairs/sets if planning RAID.

    Does the Uniview NVR301-16S3 need its own PoE switch?

    Yes — the recorder has no built-in PoE, so cameras connect through a separate managed PoE switch. Size the switch's PoE budget for the planned cameras: 802.3at (≤30 W/port) handles typical IR-equipped bullets and domes; 802.3bt (≤60-90 W/port) is needed for PTZ and heated housings.

    What power and cooling does the Uniview NVR301-16S3 need?

    Plan for 35 W idle and ~35 W under full load, dissipating roughly 119 BTU/hour into the rack or cupboard. Size the UPS for at least 15-minute hold-up so the unit can flush write buffers and shut down cleanly on mains failure — abrupt power loss is the leading cause of NVR file-system corruption in commercial installs.

    Is the Uniview NVR301-16S3 suitable for evidentiary recording?

    Depends on the retention and chain-of-custody policy. The 1-bay chassis is single-disk only; for evidentiary recording, pair with a secondary NVR or NAS for redundancy. On the export side, ensure footage is hashed and timestamped before transfer to investigators.

    Related Uniview NVRs

    Compare with similar-channel NVRs from other brands

    Helpful Tools & Resources

    Plan your CCTV layout with Uniview NVR301-16S3

    Use our free CCTV planner to lay out cameras feeding this recorder, match HDD capacity to retention windows, and generate a professional PDF report — no signup required.

    Free until you outgrow it · No card · No install